|
Here is the continuation for the V1...
part of this install calls for power for the V1. I need to draw power that is on with ignition, and the source of such power in the overhead console is the Garage Door Opener... However, I hate to use the taps, so I have built a Y-splitter using original BMW connectors and Digi-Key pins.
here is the list of parts:
61 13 8 377 072 - 3-pin socket housing - 1 piece
61 13 6 931 929 - 3-pin terminal housing -1 piece
A28327-ND - socket pins - 3 pins - Digi-Key
WM2515-ND - terminal pins - 3 pins - Digi-Key
61 13 1 378 106 - round 2-pin connector housing - 1 piece
61 13 1 378 108 - round 2-pin connector housing - 1 piece
61 13 1 376 193 - pin male w/o wire - 2 pieces
61 13 1 376 202 - pin female w/o wire - 2 pieces
Now, since I am not locked in a location within reach for V1 controls and visual, I need to figure out location for the actual unit. I can't do it while I am in VA, as detectors are illegal here, so it needs to wait until I am in PA... I will continue posting...
|