Home Forums Articles How To's FAQ Register
Go Back   Xoutpost.com > Articles > X5 > Electronics - X5
ModBargains
User Name
Password
Member List Premier Membership Search Today's Posts Mark Forums Read


 
 
LinkBack Thread Tools Display Modes
  #1  
Old 01-09-2006, 10:05 AM
Administrator
 
Join Date: Mar 2005
Location: X5world
Posts: 52
Xoutpost has disabled reputation
How to reset the Service Lights on a BMW X5

Contributed by: X5world

How to Reset Service Interval Lights
For X5's produced from October/November 2000 and beyond:

1. Key in 0 or off position.

2. Press and hold odometer button and turn key to 1 or acc. position.

3. Keep button pressed until any of the following words appear in display: "oil service" or "inspection", with "reset" or "re". For vehicles with "high cluster", the fuel amount (in litres) remaining until next service is displayed (i.e. 3224).

4. Press and hold button again until "reset" or "re" flash. If there is no "flash", minimum consumption value has not been met.

5. While display is flashing, press button briefly to reset service interval indicator. After display has shown new interval, the following will appear in display for approx. 2 seconds:"END SIA"

For model year 2000 or early production 2001's:
Resetting the service lights can be done by one of two ways, firstly specialist tools are available for around $95+ that plugs into the diagnostics port and reset the lights automatically, or you can do it manually using a paperclip or small length of wire. To do it you need to unscrew the dust cover from the diagnostics connector (attached the the suspension turret ) and turn the ignition switch to position two - this is where the accessories come on but the starter motor doesn't engage. Create a short between pins 7 and 19, hold this in position for 5 seconds for an oil service, or 10 seconds for an Inspection. See the picture below - looking at the orientation of the "pacman" helps.
Take off the piece of wire and turn off the ignition. When you turn the ignition back on you will see the service lights are all green bars.
One way to make a jumper is to use a 16 gauge wire, stripped on the ends, twisted and then folded over once to make it thicker. Just make sure you don't touch any of the other pins when one is already connected.

The light reset is done not just by time of "jump" of the pins but by breaking the circuit after the correct time. To reset Oil Service lights engage for approximately 5-6 seconds then release. For the Inspection lights, engage for approximately 10-12 seconds then release.














NOTE: Here is a picture of a post September '00 X5 - note the lack of the service port:


Sponsored Links

 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On



I


All times are GMT -4. The time now is 05:40 PM.
vBulletin, Copyright 2014, Jelsoft Enterprises Ltd. Search Engine Friendly URLs by vBSEO 3.6.0
2013 Xoutpost.com. All rights reserved. Xoutpost.com is a private enthusiast site not associated with BMW AG.
The BMW name, marks, M stripe logo, and Roundel logo as well as X3, X5 and X6 designations used in the pages of this Web Site are the property of BMW AG.
This web site is not sponsored or affiliated in any way with BMW AG or any of its subsidiaries.