|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Key won't open or close the X (PROBLEME FIXED!)
Last edited by boomer89; 09-29-2010 at 06:17 AM. |
| Sponsored Links | |
|
|
|
|
#2
|
||||
|
||||
|
Maybe the battery's dead or dying? Sounds like it's either the battery or the radiowave parts...
|
|
#3
|
|||
|
|||
|
I thought it could be that since this is probably the original key that came with the car... but last week the BMW emblem on the key fell of I dont know if that has anything to do with it or not?
|
|
#4
|
||||
|
||||
|
I never took the key apart so I don't know, but maybe some wires or other electronic parts was loosen when the emblem fell of? The emblem may be the cause, or maybe just a coincident..
|
|
#5
|
||||
|
||||
|
Do you have a second key to try? If the symptoms are the same with the other key then it might be the Basic Module 3 relays. Are you having any problems unlocking using the cental lock button?
__________________
Wake up every day that would be a start. |
|
#6
|
||||
|
||||
|
tap the key against the floor very hard or some hard surface, and the key should start working again.
|
|
#7
|
|||
|
|||
|
ok I have tried to tap it very hard against a hard surface but still no go! now if I press the open button erratically it opens the trunk but does not unlock the car? I have already purchased a new key that is on the way but I would still like to know what is going on with the key.
|
|
#8
|
|||
|
|||
|
Quote:
http://www.xoutpost.com/articles/x5/...y-fob-e53.html I'd wait until you get your new key and are sure that's working before attempting a battery replacement. Good luck! |
|
#9
|
|||
|
|||
|
Just did the reprogram on the remote as it says in the info of the link above .
Put the working key in the ignition. Turn to position 2 for like 1 second then back and remove the key. Press and hold the "unlock" button then press the "lock" button 3 times, you should hear all the locks cycle through. Now take the non working key and press and hold the "unlock" button then press the "lock" button 3 times. Then turn the ignition on and off again to end the programming.... THX a lot Radaddict! |
![]() |
| Bookmarks |
|
|
|
|